Installation & Assembly

ASSEMBLY INSTRUCTIONS

CHECK THAT YOU HAVE ALL THE

PIECES LISTED ON THE LEFT HAND

SIDE.

LAY A CLEAN SHEET ON A FLAT

SURFACE BIG ENOUGH TO ASSEMBLE

YOUR FURNITURE ON IN ORDER TO

PROTECT YOUR FURNITURE.

Lay the table top (A) down so the frame is facing upwards. With the slit facing

upwards, attach chair legs (B), to the table top by aligning the screw holes

with those in the table top (A) . Insert screws (E) through the washer and into

the holes and loosely tighten with the allen key (F).

Then insert table leg (C) into position over the slit of table leg (B) and align the

screw holes with the holes in the table top (A). Insert screws (E) through the

washer and into the holes and loosely tighten with the allen key (F) in the

locations shown in the image below.

BEFORE YOU START ASSEMBLING YOUR

FURNITURE:

G 1

Attach both the table legs together by placing the bracket (G) over the screw

holes on the bottom of table leg (B & C) as shown in the above image and

inserting the three remaining screws (E) through the washers and into the

bracket and table legs. Fully tighten using the allen key (F).

Fully tighten all of the screws in the table using the allen key (F) then place the

screw caps over all of the screws.

TABLE

TABLE ASSEMBLY INSTRUCTIONS .

PAGE 1
TABLE ASSEMBLY INSTRUCTIONS BEFORE YOU START ASSEMBLING YOUR FURNITURE: CHECK THAT YOU HAVE ALL THE PIECES LISTED ON THE LEFT HAND SIDE. LAY A CLEAN SHEET ON A FLAT SURFACE BIG ENOUGH TO ASSEMBLE YOUR FURNITURE ON IN ORDER TO PROTECT YOUR FURNITURE. A 1 B 1 C 1 D 1 E 11 F 1 G 1 1. Lay the table top (A) down so the frame is facing upwards. With the slit facing upwards, attach chair legs (B), to the table top by aligning the screw holes with those in the table top (A) .
PAGE 2
3. Turn the table upright and place the tempered glass (D) over the table top. TABLE ASSEMBLY INSTRUCTIONS .