Owner Manual

Neutral Wire From
Outlet Box
(
W hite W ire
)
Receiver
Fan
R ed W ire
with
"A C IN L " s tick er
R ed W ire
with
"A C IN N " sticke r
Hot Wire F rom
Outlet Box
(B la ck Wire)
Ground Wire
(
Green Wire )
1
23
4
1
23
4
1
23
4
1
23
4
1
23
4
1
23
4
1
23
4
1
23
4
1
23
4
1
23
4
1
23
4
1
23
4
1
23
4
1
23
4
1
23
4
1
23
4
(Fig2.)
ON DIP
1
2 3
4
Key
"ON" position
"OFF" position
(Fig1.)
FREQUENCY SETTER
(Ex-Factory Mode)
Before installing Remote Controller, make sure the Main Power
Supply is turned off.
AC:110V~130V/60Hz
LIGHT: 165W (MAX)
FAN: 60W (MAX)
Warning:
There is a frequency setter in transmitter and receiver (See Fig 1.).
First, set all of the 4 keys at "ON" position. If more than one remote
controlled fan is installed or the frequency interfered, the fan may
function abnormally. In this situation, you need to reset the fan
frequency as per following instructions.
1. Adapt the canopy to the hanger bracket.
2. Please use a ball pen (or any convenient tool) to poke
keys to select a desired frequency mode which will not
interfere with other electrical units. There are 15 frequency
modes for selection excluding the original ex-factory
mode (See Fig 2.).
NOTE: Do not set the remote controlled fans at the same
frequency in the same building.
3. Install a 9V battery (not included) into the transmitter.
4. Turn on the power.
5. Press button to operate the fan.
*** Please note to change the frequency-setters in the transmitter
& receiver at the same time & at the same key position.***
Step 1: Make wire connection.
Step 2: Set Frequency before making wire connection.
1.
White Wire
from outlet box to Red Wire from receiver
with "AC IN N" sticker.
2. Black Wire from outlet box to Red Wire from receiver
with "AC IN L" sticker.
3. Black Wire from receiver to Black Wire from motor.
4. Blue Wire from receiver to Blue Wire from motor.
5.
White Wire
from receiver to
White Wire
from motor.
6. Orange Wire from Receiver to Red Wire from Motor.
7. Ground Wire from outlet box to Green Ground Wire
from hanger bracket & downrod.
8. Install a 9V battery (not included) into the transmitter.
Turn on the power. Press button to operate the fan.
REMOTE CONTROLLER WIRING CHART
1). When 1 key is in "OFF" position.
2). When 2 keys are in "OFF" position.
3). When 3 keys are in "OFF" position.
4). When 4 keys are in "ON" or "OFF" position.
U/L
D/L
HI
MED
LOW
OFF
REMOTE
CONTROL
U/L
D/L
OFF
HI
MED
LOW