Installation Instructions

CERTIFICATION: UL WET

WIRE CONNECTIONS

Connect the black supply wire to the black

fixture wire. Secure with the supplied wire nuts. Connect the

white supply wires to the white fixture wire. Secure with the

supplied wire nuts. Either wrap the green wire around one of

the protruding screws or connect it to the supply ground wire.

Secure all wire with electrical tape (not supplied).

Tuck all wires carefully into the J-Box.

MOUNT FIXTURE TO CROSSBAR

Position the fixture over the crossbar.

Align the side holes of the fixture and secure with the

supplied screws.

** This fixture is wet location rated. In order to ensure

that moisture does not enter the outlet box and cause

a short circuit, clear caulking should be used to seal the

space between the fixture mounting bracket and the

wall. Ensure that a space is left at the bottom to allow

for the escape of moisture. It is required that Indoor/

Outdoor Silicon Sealant be used for that purpose**

If the fixture is to be removed or replaced,

please ensure that the electricity is

switched off and that the fitting is cool

before touching it.

CAUTION

RESTORE THE ELECTRICITY AND

CHECK THE OPERATION OF YOUR