Assembly Instruction

ASSEMBLY INSTRUCTION

NOTE: Please consult a qualified electrician if you are not certain of the installation or service.

CAUTION: Before starting the installation or service, disconnect the power by turning off the circuit

breaker or by removing the fuse at the fuse box.

1. Carefully unpack the fixture, lay out all parts on a clean surface.

2. Fasten the mounting ring onto the outlet box by using provided 2 outlet box screws.

3. Place the nipples D through the canopy, place the washer A and washer B onto the nipple D, then using

the spanner, tighten the hex nuts to the nipples D until they hold firmly.

4. Screw the nipple A into the bushing, screw nipple B into the tube A, screw the nipple C into the tube B.

5. Tie ground wire from outlet box and from fixture to the ground screw on the mounting strap. Connect

white wire from fixture to white wire (neutral wire) from supply circuit. Connect black wire from

fixture to black wire (live wire) from supply circuit. Cover connections using provided wire

connectors.

6. Place the canopy to the outlet box by aligning the protruding mounting screws all the way through the

canopy and tighten the fixture using lock nuts provided until fixture body is held firmly.

7. Unscrew the socket rings and covers from the sockets. Place the shades and socket covers over the

sockets, refasten the socket rings to secure them.

8. Install the bulb (Not included). Turn on the power.

PAGE 1
ASSEMBLY INSTRUCTION NOTE: Please consult a qualified electrician if you are not certain of the installation or service. CAUTION: Before starting the installation or service, disconnect the power by turning off the circuit breaker or by removing the fuse at the fuse box. 1. Carefully unpack the fixture, lay out all parts on a clean surface. 2. 3. Fasten the mounting ring onto the outlet box by using provided 2 outlet box screws.
PAGE 2
INSTRUCCIÓN DE ASAMBLEA NOTE: Por favor, Consulte con un electricista cafificado en caso de que esté seguro de la instalación. CAUCIÓN: Antes de comenzar la instalación, cortar la electricidad mediante apagar el cortacircuitos o quitar el fusible desde la caja de fusible. 1. Desempaquetar cuidadosamente la instalación, disponer todas las piezas sobre una superficie límpia. 2. Abroche la correa de montaje a la caja de salida usando los dos tornillos de la caja de salida. 3.