Installation & Assembly

STEP 1:
STEP 2:
Please put the Chair Body (1) upside down on a carpeted or padded area.
Then open the zipper on the bottom of Chair Body (1), to make the inside of the Chair Body (1) fully visible.
Insert the Left Front Leg (2) into the right bottom hole on the Chair Body (1) as shown.
Attach the Left Front Leg (2) by using 2 pieces of Bolt (B), 2 pieces of Spring Washer (C) and 2 pieces of Flat Washer (D).
Repeat the same steps for Right Front Leg (3).
Do not fully tighten Bolts (B) for either leg.
Insert 1 piece of Back Leg (4) into the upper hole on the bottom of Chair Body (1) as shown.
Attach them by 2 pieces of Bolt (A), 2 pieces of Spring Washer (C) and 2 piece of Flat Washer (D) as shown.
Repeat the same steps for the remaining Back Leg (4).
Do not fully tighten Bolts (A) for either leg at this step also.
2
Bx4 Dx4 Cx4
Hardware & Tool required
1
B
C
D
Ax4 Dx4 Cx4
Hardware & Tool required
1
2
3
4
C
D
A
3
1
4
DINING CHAIR
Page 2 of 3