Owner Manual

This Manual Is Designed to Make it as Easy as Possible for You to
Assemble, Install, Operate and Maintain Your Ceiling Fan
Tools Needed for Assembly
One Phillips head screwdriver
One 1/4" blade screwdriver
One stepladder
One wire stripper
Three wire connectors (supplied)
Materials
Wiring electrical box and box connectors must be of
type required by local code. The minimum wire would
be a 3-conductor (2-wire with ground) of size shown at
right.
Installed Wire Length Wire Size A.W.G.
Up to 50 ft. 14
50 - 100 ft. 12
1.Check to see that you have received the following
parts:
NOTE: If you are uncertain of part description,
refer to exploded view illustration.
a. Fan housing
b. Mounting plate
c. Fan motor assembly
d. Five fan blades
e. Five blade flanges with captive screws
f. One loose parts bag containing:
1. Sixteen M5 x 6mm Phillips washer
head screws
3. Five M5 x 10mm Phillips pan head screws
with internal tooth washers
4. Four 1/4” hex locknuts
5. One wood pendant
6. One chain coupling
7. Three wire connectors
NOTE: Place the parts from the loose parts bag in
a small container to keep them from being lost. If
any parts are missing, contact your local retailer
or catalog outlet for replacement before
proceeding.
2. Remove the fan assembly from the protective
plastic bag. Place the fan assembly into the upper
foam pad with the lead wires up.
Unpacking Instructions
For your convenience, check-off boxes are provide next to each step. As each step is completed, place a
check mark in the box. This will insure that all steps have been completed and will be helpful in finding
your place should you be interrupted.
FAN
BLADES
UPPER
FOAM PAD
MOUNTING
PLATE
FAN
HOUSING
BLADE FLANGES WITH
CAPTIVE SCREWS
FAN
MOTOR
ASSEMBLY
LOWER
FOAM PAD
CARTON
Before assembling your ceiling fan, refer to section on
proper method of wiring your fan (page 5). If you feel
you do not have enough wiring knowledge or
experience, have your fan installed by a licensed
electrician.
WARNING
!
Do not install or use fan if any part is damaged or
missing.
WARNING
!
WARNING
!
3
This product is designed to use only those parts
supplied with this product and/or any accessories
designated specifically for use with this product.
Substitution of parts or accessories not
designated for use with this product could result in
personal injury or property damage.
2. M5 x 13mm Phillips pan head screw with
lockwasher
M6 x 14mm Phillips pan headscrew with
lockwasher