Assembling & Installation Instructions

WARNING! SHUT POWER OFF AT FUSE OR CIRCUIT BREAKER .
ASSEMBLING THE FIXTURE (Fig.2).
1. Raise the trestle(C) down flush to crossbeam of the fixture
body(G), tighten it with the screws(D) .
2. Put the crystal plate(F) onto the lamp holder. Attach small cover(E)
to the top of candle sleeve, this small cover have only at both ends
of the lamp holder. Attach the cloth shade (I) onto the candle
sleeve, lock it securely with the check ring(H).
3. Install the light bulbs in accordance with the fixture specifications
NOTE: DO NOT EXCEED THE SPECIFIED WATTAGE!
HANGING THE FIXTURE (Fig.1)
1. Shut off the power at the circuit breaker and remove old fixture
from ceiling, including the old single bar.
2. Carefully unpack new fixture and lay all the parts on a clear
surface.
3. Thread the two mounting screws about 1/4" into the pre-drilled
holes in the mounting plate, spaced about the same distance apart
as the holes in the canopy(A). Attach the mounting plate to the
junction box using two junction box screws. The side of the
mounting plate marked "GND" must face out. The junction box is
not include.
4. By measuring, determine correct number of links needed for
proper hanging height. Using proper chain pliers disconnect and
discard remaining chain, connect to the fixture body loop. Close
the link(B).
5. Lace the fixture body wires through the chain.
6. Open the other end link of the chain and hang the canopy on the
loop at the ceiling. Close the link(B).
7. Feed the fixture wires through the loop and pull until taut.
8. Slide canopy(A) up flush to ceiling, lock it securely with the ball
nut.
CONNECTING THE WIRES (Fig.3)
1. Take the black wire from the ceiling junction box and the smooth
wire leg from the fixture and twist bare ends together. Twist wire
connector onto end of wire until snug.
2. Repeat same process with white junction box wire and ribbed wire
leg of fixture wire. NOTE: Twist wires together in the same
direction you twist the wire connector onto wires.
3. If your junction box has a grounding wire (green or bare copper),
attach this wire and the bare copper wire from the fixture together
as step 1. If junction box has no ground wire, attach the bare
copper fixture wire to the green ground screw on the single bar.
4. Tuck these wire connections neatly into the ceiling junction box
and then raise the canopy (A) all the way to the ceiling, lock it
securely with ball nut.
Your installation is now complete. Return power to the junction
box and test the fixture.
Fig.1
M
o
u
n
t
i
n
g
p
l
a
t
e
F
i
x
t
u
r
e
w
i
r
e
S
u
p
p
l
y
w
i
r
e
M
o
u
n
t
i
n
g
s
c
r
e
w
F
i
x
t
u
r
e
J
u
n
c
t
i
o
n
B
o
x
(
N
o
t
i
n
c
l
u
d
e
)
G
r
o
u
n
d
W
i
r
e
G
r
o
u
n
d
W
i
r
e
B
a
l
l
n
u
t
Fig.2
Fig.3
White or
HOUSE
Black
WIRES
(Hot)
Smooth
FIXTURE
WIRES
Black or
Ribbed
WIRES
FIXTURE
Bare Copper(Ground)
FIXTURE
WIRES
Copper
(Ground)
HOUSE
(Neutral)
WIRES
White
Bare
Green or
WIRES
HOUSE
ASSEMBLING & INSTALLATION INSTRUCTIONS