Assembling & Installation Instructions

ASSEMBLING & INSTALLATION INSTRUCTIONS
The drawing shown may not exactly match the product enclosed.
However, the installation instructions do apply to this product.
 WARNING! SHUT POWER OFF AT FUSE OR CIRCUIT BREAKER.
 ATTENTION! COUPER LE COURANT AU FUSIBLE OU UN DISJONCTEUR.
ASSEMBLING THE FIXTURE (Fig.1)
1. Shut off the power at the circuit breaker box. Remove old fixture and all
hardware from Junction Box. Carefully unpack your new fixture and lay out
all the parts on a clear area. Take care not to lose any small parts
necessary for installation.
2. Raise the big loops(B) onto the top pipe thread of lamp body(D), by turn it
clockwise until tight.
3. Install the light bulbs(Not included) in accordance with the fixture’s
specifications. NOTE: DO NOT EXCEED THE SPECIFIED WATTAGE!
4. Slide the electrical wires through the chain(A) and canopy. Open the end
link, hooked the loops of the canopy and lamp body(D), then close the
open link.
5. By measuring, determine correct distance hole in mounting plate, then
drilled two holes(by measuring distance hole) in the ceiling at junction box
of side; raise the plastic anchor insert the hole. Thread the two mounting
screws about 1/4" into the pre-drilled holes in the mounting plate, spaced
about the same distance apart as the holes in the canopy. Attach the
mounting plate to the junction box with two junction box screws and two
wood screws, tighten screws securely with screwdriver. The side of the
mounting plate marked "GND" must face out. The junction box is not
included.
6. While holding the fixture body towards the ceiling, connect the electrical
wires as Shown in Fig.2, making sure that all wire nuts are secured. You
may have to wrap the connections with electrical tape. If your outlet has a
ground wire (green or bare copper), connect the fixture ground wire to it.
Otherwise connect fixture’s ground wire directly to the Mounting plate with
the green screw provided. After wires are connected, tuck them carefully
inside the Junction Box.
7. Raise the canopy onto the Junction box, aligning the mounting screws with
mounting hole in canopy and lock it securely with the finial(C).
Your installation is now complete. Return power to the
junction box and test the fixture.
Green
(GND)
Mounting
Screw
Plate
anchor
Screw
Screw
C
A
BD
FIXTURE
WIRES
Black or
Smooth
HOUSE
WIRES
Black(Hot)
FIXTURE
WIRES
White or
Ribbed
FIXTURE
WIRES
Bare
Copper
(Ground)
HOUSE
WIRES
White
(Neutral)
HOUSE
WIRES
Green or Bare
Copper(Ground)
FIG.2 FIG.1
Thank you for purchasing a product.
Need assistance with parts or assembly? Please call customer service