Installation Guide

WALL INSTALLATION GUIDE

All electrical connections and the installation of this fixture must be in agreement with local codes,

ordinances or the NEC (National Electric Code) or CEC (Canadian Electrical Code).

Do not connect this fixture to an electrical system that does not provide a means for equipment grounding.

CAUTION: Read instructions carefully before installing Fitter.

NOTE:

Shade is for instructional

purposes. Actual Shade

may vary in size and shape.

1. Disconnect power to outlet box at main electric box.

2. Fasten the mounting bracket (A) to the outlet box using the screws provided (B).

3. Turn the two Threaded Posts (C) into the inner holes of the Mounting Bracket (C). Rotate the Mounting Bracket so

the posts are oriented as shown.

4. Attach the Ground Wire to the Green Ground Wire on the fixture with WIre nut (I).

5. Hold the Fixture (E) close to the outlet box and connect the Fixture Wires to the House Wires with Wire nuts (D):

Black to Black and White to White. Carefully push the wires and wire nuts back into the outlet box.

6. Place the Fixture against the wall over the outlet box so that the Threaded Nipple protrudes through the hole on

Fixture. Place the Cap Nuts (F) onto the Threaded Nipple and tighten securely.

7. Partially install the 3 Hex Set Screws (H) into the fixture.

8. IMPORTANT: IN ORDER TO COMPLY WITH ESTABLISHED ELECTRICAL CODE, THE INSTALLER MUST SEAL

THE AREA AROUND THE FIXTURE AND THE WALL WITH A TYPE OF CAULKING COMPOUND SUCH AS

SILICONE RUBBER TO PROVIDE A WATERTIGHT SEAL IN ACCORDANCE WITH THE DIFFERING SURFACE

TEXTURES OF THE WALL.

9. With the power will off, insert lamp.

10. Install Shade by placing onto the previously installed Fixture (E):

For Wireform Shades: Use Short Hex Set Screws and align Hex Set Screws with Metal Frame of the Wireform

Shade and do not align the holes. Using Allen Wrench provided, tighten the three Hex Set Screws to the Metal

Frame of the Wireform Shade.

For Glass Shade: Use Long Hex Set Screws and align Set Screws with Holes in Glass Shade. Tighten, with Hand

or Allen Wrench provided, the three Hex Set Screws.

11. Restore power.

For Glass Shade Align

the Holes to the Set Screws.

IMPORTANT: Holes on the

Wireform are NOT for use

with Set Screws. Do not

align Holes with the Set

Screws.