Installation & Assembly

Adjust according to

the ground level.

STEP 1

Attach mirror support (C) to the mirror back (A) as step 1,

then tighten with JCBC M6 x 35mm (1). Make sure the

marking line on mirror support is at the same level as the

bottom of mirror.

STEP 2

Place the mirror with support on the top of dresser (B). Then

align center as shown and tighten with JCBC M6 x 35mm (1).

Center mark

Thank you for purchasing this quality product. Be sure to check all packing material carefully for small parts which may

have come loose inside the carton during shipment. Identify and count all parts and compare with the parts List Below:

ASSEMBLY INSTRUCTION

DESCRIPTION

PART LIST

MIRROR & 8 DRAWER DRESSER

DESCRIPTIONS

QTY

NO. SKETCH

A Mirror

Dresser

Mirror Support

JCBC M6 x 35mm

Spring Washer 1/4"mm

Flat Washer 1/4" x 20mm

L Key M4

1 Unit

2 Pcs

8 Pcs

1 Pc