Installation Instructions
CAUTION
Please read this entire manual before installation and use of fixture.
IMPORTANT - Observe all local governing codes and ordinances.
IMPORTANT - Save these instructions for later use.
Installation of lights and electrical work may present a possible shock or re hazard if improperly installed or used. All
electrical work should be performed in accordance with all federal, state and local safety regulations and require proper
grounding. All work should be performed by a certied electrician. Before starting installation, turn OFF electricity at the
main fuse or circuit breaker that controls the power to the xture/room you are working on.
CARE INSTRUCTIONS:
DO NOT use abrasive or chemical cleaners to clean the light as it may damage the nish. Use only warm water, then wipe
dry with a clean, soft cloth.
TROUBLESHOOTING AND REPAIR:
IMPORTANT SAFETY INSTRUCTIONS:
• Do not use with damaged electrical cords.
• Never overload electrical circuits as it may cause electrical shock or re.
• Do not look directly into the light source.
WARNING
Keep children away from packaging
INSTALLATION INSTRUCTIONS
INTERCHANGEABLE BARN LIGHT
LIMITED WARRANTY:
Check for damaged or worn parts before installation. Broken or damaged parts will aect the products operation. Replace or
repair damaged or worn parts immediately. Should the light stop working properly and/or one of the following problems
occur: (1) The lamp fails to turn on (2) The lamp ickers (3) The lamp dims to an unusual level, check all connections and
then turn the lamp back on. If the problem persists, disconnect the lamp and contact customer service.