Assembly Instructions

2 of 2
Assembly Instructions
Important
• Always disconnect the power before installing or replacing bulbs and before cleaning or other maintenance.
• Consult a qualied, licensed electrician to ensure correct branch circuit conductor.
Consulter un électricien qualié pour vous assurer que les conducteurs de la dérivation sont adéquats.
1. Shut off power to the outlet box (A).
2. Make appropriate electrical connections using wire nuts:
a. Connect the LED driver’s (B) live wire (black) to the live outlet box wire.
b. Connect the LED driver’s (B) neutral wire (white) to the neutral outlet box wire.
c. Connect the xture’s ground wire (green or uncoated) to the ground outlet box wire. If no ground is present in
outlet box, connect xture’s ground wire to the mounting plate (C) using the green screw (included).
d. Carefully place connections and LED driver (B) in outlet box (A).
3. Attach the mounting plate (C) to the outlet box (A), secure with outlet box screws (D).
4. Install the back plate (E) to the mounting plate (C) by hooking the bracket in the back plate onto the upper bend (F) on
the mounting plate. Secure with mounting set screws (G) using included Allen wrench (H).
For Wet Location Use: Fixture must be installed in the orientation shown and mounted minimum 4' above the ground.
5. For Wet Location Use: Place a small bead of silicone or water proof caulk (not included) around the back plate (E)
where it comes in contact with the wall.
6. Screw the lenses (J) to the top and bottom of the xture (K). For the Plate Lens, tighten using the included tool (L).
WARNING: Do not touch or press on the LEDs inside the xture, or they will be damaged.
7. Restore power to the xture.
Note
• The outlet box must be at least 4” DIA and 1.5” deep to t the LED driver.
• This xture is dimmable with Electronic Low Voltage (Trailing-Edge) type and Incandescent (Leading-Edge) type
dimmers. For best performace, we recommend using an Electronic Low Voltage dimmer.
Care Instructions
• Dusting: Use a clean, dry cloth.
• Cleaning: To protect the nish, avoid any harsh abrasives or chemicals.
A
B
C
F
G
L
D
E
J
K
H
DL - Dome Lens
FH - Clear
Cylinder Lens
FW - White
Cylinder Lens
PL - Plate Lens
INSTRUCTIONS D’INSTALLATION
Up/Down LED Sconce