Assembly Instructions

2 of 2

Important

• Always disconnect the power before installing or replacing bulbs and before cleaning or other maintenance.

• Consult a qualied, licensed electrician to ensure correct branch circuit conductor.

Consulter un électricien qualié pour vous assurer que les conducteurs de la dérivation sont adéquats.

1. Shut off power to the outlet box (A).

2. Make appropriate electrical connections using wire nuts:

a. Connect the LED driver’s (B) live wire (black) to the live

outlet box wire.

b. Connect the LED driver’s (B) neutral wire (white) to the

neutral outlet box wire.

c. Connect the xture’s ground wire (green or uncoated)

to the ground outlet box wire. If no ground is present

in outlet box, connect xture’s ground wire to the

mounting plate (C) using the green screw (included).

d. Carefully place connections and LED driver (B) in

outlet box (A).

3. Attach the mounting plate (C) to the outlet box (A), secure

with outlet box screws (D).

4. Install the xture (E) to the mounting plate (C) by

hooking the bar in the xture onto the upper bend (F) on

the mounting plate. Secure with mounting screws (G)

using included Allen wrench (H).

For Wet Location Use: Fixture must be installed in a

vertical orientation with the drain hole positioned on the

bottom end and mounted minimum 4’ above the ground.

5. For Wet Location Use: Place a small bead of silicone or

water proof caulk (not included) around the xture (E)

where it comes into contact with the wall.

6. Restore power to the xture.

Note

• The outlet box must be at least 4” DIA and 1.5” deep to t the LED driver.

• This xture is dimmable with Electronic Low Voltage (Trailing-Edge) type and Incandescent (Leading-Edge) type

dimmers. For best performance, we recommend using an Electronic Low Voltage Dimmer.

Care Instructions

• Dusting: Use a clean, dry cloth.

• Cleaning: To protect the nish, avoid any harsh abrasives or chemicals.

INSTRUCTIONS D’INSTALLATION

18" LED Sconce, 24" LED Sconce, 36" LED Sconce