Assembly Instructions

2 of 2

Important

1. Shut off power to the outlet box (A).

2. Make appropriate electrical connections using wire nuts:

a. Connect the LED driver’s (B) live wire (black) to the live outlet box wire.

b. Connect the LED driver’s (B) neutral wire (white) to the neutral outlet box wire.

c. Connect the xture’s ground wire (green or uncoated) to the ground outlet box wire. If no ground is present in

outlet box, connect xture’s ground wire to the mounting plate (C) using the green screw (included).

d. Carefully place connections and LED driver (B) in outlet box (A).

3. Attach the mounting plate (C) to the outlet box (A), secure with outlet box screws (D).

Note

• The outlet box must be at least 4” DIA and 1.5” deep to t the LED driver.

• This xture is dimmable with Electronic Low Voltage (Trailing-Edge) type and Incandescent (Leading-Edge) type

dimmers. For best performance, we recommend using an Electronic Low Voltage Dimmer.

Care Instructions

• Dusting: Use a clean, dry cloth.

• Cleaning: To protect the nish, avoid any harsh abrasives or chemicals.

• Always disconnect the power before installing or replacing bulbs and before cleaning or other maintenance.

• Consult a qualied, licensed electrician to ensure correct branch circuit conductor.

Consulter un électricien qualié pour vous assurer que les conducteurs de la dérivation sont adéquats.

For Wet Location Use: Fixture must be installed in the orientation shown and mounted minimum 4’ above the ground.

4. Install the xture (E) to the mounting plate (C) by hooking the bar in the xture onto the upper bend (F) on the

mounting plate. Secure with mounting set screws (G) using included Allen wrench (H).

5. For Wet Location Use: Place a small bead of silicone or water proof caulk (not included) around the xture (F) where it

comes into contact with the wall.

6. Restore power to the xture.

INSTRUCTIONS D’INSTALLATION

LED Sconce