Assembly Instructions

2 of 3

INSTRUCTIONS D’INSTALLATION

16" LED Bollard, 22" LED Bollard, 28" LED Bollard

16" LED Double Bollard, 22" LED Double Bollard, 28" LED Double Bollard

Important

• Always disconnect the power before installing or replacing bulbs and before cleaning or other maintenance.

• Consult a qualied, licensed electrician to ensure correct branch circuit conductor.

Consulter un électricien qualié pour vous assurer que les conducteurs de la dérivation sont adéquats.

1. Shut off power to the branch circuit conductor.

2. Install a 12VAC output magnetic transformer in an accessible location,

and run low voltage outdoor power cable (A) from the transformer to the

desired bollard location in accordance with local codes. To avoid

excessive voltage drop, you must use power cable with appropriate wire

gauge for the distance and load of your system. The bollards can accept

an input voltage from 10 to 15VAC.

3. For Concrete Mounting: Using the provided temporary template (Fig. 1),

cast the anchor bolts (B) and low voltage outdoor power cable (A) into a

concrete footing (C). Arrange the anchor bolts so at least 1/2" of

threaded and no unthreaded length is exposed above the concrete.

Arrange the power cable so that it is in the center of the template, with

at least 6" of cable exposed above the concrete.

4. For Concrete Mounting: Once the concrete (C) has fully cured, remove

and discard the template.

5. For Concrete Mounting: Place mounting plate (D) over the

anchor bolts (B) and power cable (A). Secure with mounting nuts (E).

For Wood Mounting: Place mounting plate (D) over the power cable (A)

and secure with lag screws (not included).

6. Make appropriate electrical connections using outdoor wire nuts (F):

a. Connect one of the power cable (A) conductors to one of the

xture's input conductors.

b. Connect the other power cable (A) conductor to the xture's other

input conductor.

c. Carefully place the conductors and connections into the post (G).

7. Place the post (G) over the mounting plate (D). Secure with

mounting screws (H).

8. Restore power to the xture.

Note

• This xture is not dimmable.

Care Instructions

• Dusting: Use a clean, dry cloth.

• Cleaning: To protect the nish, avoid any harsh abrasives or chemicals.