Installation Instruction

FIG.2
Fixture Wires
Black or
Smooth
Fixture Wires
White or
Ribbed
Fixture Wires
Bare Copper
(Ground)
House Wires
Black
(Hot)
House Wires
White
(Neutral)
House Wires
Green or Bare Copper
(Ground)
PREPARATION
1. Shut o the power at the circuit breaker and remove
existing xture, including the mounting hardware.
2. Carefully unpack your new xture and lay out all the
parts on a clear area. Be careful not to
lose any small parts necessary for installation.
MOUNTING THE FIXTURE (Fig. 1)
3. Remove the mounting screws (I1) from the
xture frame (J1), and set aside for re-assembling
the xture.
4. Drill the holes in the proper position on the
wall according to the keyholes located on
the mounting back plate (H1). Insert the
plastic anchors (C1) into the wall.
CONNECTING THE WIRES (Fig. 2)
5. Connect the electgrical wires as shown in Fig. 2
making sure that all wire connectors (A1) are secured.
Fixture and junction box ground wires should be
connected to mounting plate using green screw provided.
After wires are connected, tuck them carefully
inside the junction box.
6. Secure the mounting back plate (H1) to the junction box
(E1) using junction box screws (B1). Fasten to the wall using
the wood screws (D1).
COMPLETING INSTALLATION (Fig. 1)
7. Place the xture frame (J1) over the mounting back plate (H1).
Make sure the bottom of the frame is aligned to the bottom of the
back plate as shown in Fig.1.
8. Secure the xture frame (J1) to the mounting back plate with
the mounting screws (I1).
I1
D1
C1
G1
B1
A1
F1E1
H1
C1
D1
J1
FIG.1
100%-10% DIMMING
COMPATIBLE WITH THE FOLLOWING ELECTRONIC
LOW VOLTAGE (ELV) DIMMERS
Brand Model
LUTRON DVELV-300P, SELV-300P
Anchor
Mounting
screw
Wood
screw
Junction
Box screw
Wire
Junction
Box
Mounting
plate
Anchor
Screw
Wire
connector
Fixture
INSTALLATION INSTRUCTION