Assembly Instruction

1. Determine the height for this FLUORESCENT LAMP FITTING, and adjust the wire length.
2. Fasten CROSSBAR (1) to junction with SCREWS (2).
3. Connect the WHITE WIRE (LIVE) (4) from FITTING to the WIRE (LIVE) from power supply by using
the WIRE NUT (6). Connect the BLACK WIRE (NEUTRAL) (3) to the WIRE (NEUTRAL) from
power supply by using the WIRE NUT (6). Connect the GROUND WIRE (5) from the CANOPY (7) to
OUTLET BOX, make the electrical connections by using the WIRE NUT (6).
4. Attach the CANOPY (7) to the CROSSBAR (1) with SCREWS (8).
5. Drill the suitable hole in the ceiling and insert the PLASTIC TUBE (9), then install the
HOOK (10) into the PLASTIC TUBE (9).
6. Make the steel wire a ring and tighten with WIRE FIXERS (11), then hang up the
FLUORESCENT LAMP FITTING to the HOOK (10).
7. Push COVER CUP (12) to the right place.
8. The steps to replace the FLUORESCENT TUBE: (a1) Open the LAMP COVERS. (a2)
Turning the FLUORESCENT TUBE then pull them out. (b1) Install the FLUORESCENT
TUBE into the lamp-sockets.(b2) Fasten the LAMP COVERS to junction of the
FLUORESCENT LAMP FIXUTRE.
Input: 120v ~50/60Hz Watt: 28W X 2
Use 28W (Maximum) T5 Fluorescent tube (Tube included).
4
WHITE WIRE
5
3
GROUND WIRE
1
CROSSBAR
7
CANOPY
BLACK WIRE
2
SCREW
8
SCREW
6
WIRE NUT
9
PLASTIC TUBE
10
HOOK
11
WIRE FIXER
12
COVER CUP
LAMP
b1
a2
b2
a1
LAMP COVER
FLUORESCENT TUBE
ASSEMBLY INSTRUCTIONS
※ PLEASE INFORM YOUR DEALER IMMEDIATELY IN CASE OF ANY PARTS SHORTAGE.
※ SAVE THESE INSTRUCTIONS FOR FUTURE REFERENCE.
※ THIS LIGHTING FIXTURE CAN NOT BE INSTALLED IN THERMORADIACTIVE ENVIRONMENT.