Installation & Assembly

Page 7 of 7
To install the batteries (not included),
remove the screw that holds the battery
cover by using a Phillips screwdriver.
Install new AA-size 1.5-volt alkaline
batteries with correct polarity (,) by
following the illustration inside the
battery cover. Close the battery cover
and tighten back the screw.
#1
I. With the help of another person, carefully place the table upright.
II. Align the glass strip (#4) with the pre-drilled holes of the table
top (#1).
III. Prepare two bolt assemblies by inserting FIRST the lock washer
(#F) onto the bolt (#C) and then the flat washer (#E) onto the
SAME bolt (#C), in that order.
IV. Insert the bolt assemblies through the pre-drilled holes under the
table top (#1) and secure those bolt using the Allen wrench (#G)
to lock them with the glass strip (#4).
Caution:
 Use batteries of the same type.
 Do not mix old and new batteries.
 Do not mix alkaline, standard (carbon-zinc), or rechargeable (nickel-cadmium) batteries.
 Do not use rechargeable batteries.
 Do not try to recharge non-rechargeable batteries.
 Remove exhausted or corroded batteries.
 If light is not used for more than a week, remove the batteries to prevent depletion and corrosion.
#C x 2 pcs
#E x 2 pcs
#F x 2 pcs
Make sure the table is rested on a
flat surface and does not feel loose
or wobbly. If it does, double check
that the bolts/screws are secured
and properly tightened.