Assembly Instructions

Step 1
I. Place the back rest with legs (#1) on a
protected surface. Insert the wood dowel
(#G) to the center hole of the back rest
with legs (#1).
II. Align the seat cushion (#2) with the wood
dowel (#G) and the pre-drilled holes of the
back rest with legs (#1).
III. Prepare 2 bolt assemblies by inserting
FIRST the spring washer (#E) onto the
bolt (#C) and then the flat washer (#F)
onto the SAME bolt (#C), in that order.
IV. Insert the bolt assembly through the hole
between the wood dowel (#G) and the
edge of the seat cushion (#2) and secure
that bolt using the Allen wrench (#A) to
lock it in with the back rest with legs (#1).
Repeat for the other side.
V. Prepare 4 bolt assemblies by inserting
FIRST the spring washer (#E) onto the
bolt (#B) and then the flat washer (#F)
onto the SAME bolt (#B), in that order.
VI. Insert 2 bolt assemblies through the two
pre-drilled holes in the corner of the seat
cushion (#2) and secure those bolts using
the Allen wrench (#A) to lock it in with the
back rest with legs (#1). Repeat for the
other side.
Step 2
I. Insert the 2 legs (#3) to align with the
pre-drilled holes of the seat cushion (#2).
II. Prepare 4 bolt assemblies by inserting
FIRST the spring washer (#E) onto the
bolt (#D) and then the flat washer (#F)
onto the SAME bolt (#D), in that order.
III. Insert 2 bolt assemblies through the two
pre-drilled holes in the corner of the seat
cushion (#2) and secure those bolts
using the Allen wrench (#A) to lock it in
with the leg (#3). Repeat for the other
side.
IV. Carefully turn the completed chair
upright. Make sure the chair is rested on
a flat surface and it does not feel loose or
wobbly. If it does, double check that the
bolts are secured and properly tighten.
Turn right (clockwise) to tighten
Turn right (clockwise) to tighten
Page 4 of 4
2
#B x 4 pcs
#C x 2 pcs
#E x 6 pcs
#F x 6 pcs
#D x 4 pcs
#E x 4 pcs
#F x 4 pcs
C
Assemble everything exactly
the same for the second chair.