Assembly And Installation Instructions
ASSEMBLY AND INSTALLATION
INSTRUCTIONS
NOTES: 1. Before installing, consult local electrical codes for wiring and grounding requirements.
2. READ AND SAVE THESE INSTRUCTIONS.
Hardware Package (included):
WARNING:
TO AVOID RISK OF ELECTRICAL SHOCK, BE SURE TO SHUT OFF
POWER BEFORE INSTALLING OR SERVICING THIS FIXTURE.
Turn off the power at fuse or circuit box
Green Grounding
Screw (E)
Fixture Mounting
Screw(D)
Mounting Screw (B)
Wire Nut (C)
Installation Steps
Lock Nut (F)
Ball Nut (G)
Canopy
Metal Pad1
Washer
Ball Nut (G)
Cover
Cover
Threaded pipe1
Coupling
Coupling
Brackets
Threaded Pipe2(H)
Metal Pad2(J)
Hex Nut
Hex Nut(I)
Diffuser
Frosting
Decorative Cup(K)
Finial(L)
Socket
Housing
Shade
Tube
Outlet Box
House Grounding Wire
Wire Nut(C)
Fixture Mounting Screw (D)
Mounting Strap(A)
Green Grounding Screw(E)
Lock Nut(F)
Mounting Screw(B)
Hex Nut
Hex Nut
Washer
Mounting Strap (A)
Hex Nut (I)
Metal Pad (J)
Threaded Pipe2 (H)
Decorative Cup (K)
Finial (L)
1. Thread the fixture mounting screws through mounting strap,
and then secure them with two lock nuts. Adjust the length
of fixture mounting screws if necessary.
2. Attach mounting strap to the outlet box using two mounting
screws.
3.
Thread the fixture wire through the washer,hex nut
and threaded pipe1.
4. Secure the threaded pipe1 into the coupling of the shade
with the washer and hex nut untill tightened.
5. Attach the tube onto the cover of the shade and thread the fixture
wire through the cover,canopy,metal pad1,washer and hex nut. Place
the cover and canopy onto the tube through the threaded pipe1,
then tighten them with the metal pad,
washer and hex nut.
6. Secure the threaded pipe2 into the
coupling of the housing and tighten it
with the hex nut.
7. Slip the metal pad2,diffuser and
decorative cup up through the
threaded pipe2, and then secure them
with the finial.
NOTE: The depth of hex nut in
threaded pipe2 may need to be
adjusted to properly fit the diffuser. The diffuser
should be flatly laid on four brackets,
and the frosting of the diffuser should
be faced down.
Bulb Type A Max.60W
(not included)