Assembly And Installation Instructions

A
B
C
Turn off the power at fuse or circuit box
Turn on the power at fuse or circuit box
Installation Steps
The following parts are available for re-order if damaged or missing.
Spare Parts List:
A: 5-1/4 "
B: 33"
C: 5-1/4
"
1. Unsecure the ball nuts, carefully remove mounting plate from back plate.
2. Attach the mounting plate to the wall.
a) If the wall material is wood:
Attach the mounting plate to the outlet box by using two mounting screws, then secure the dry wall
screws through the set holes to the wall.
b) If the wall material is cement:
Place the mounting plate to the outlet box and mark the target on the wall from the set hole for
drilling two holes. Remove the mounting plate. Drill the holes and thread the anchors into the holes,
then attach the mounting plate to the outlet box by using two mounting screws. Secure the dry wall
screws through the set holes into the anchors.
3. Pull out the source wires from the outlet box. Make wire connections using wire nuts as follows:
---Connect the hot wire (usually black insulation) from the fixture to the black wire from the power source.
---Connect the neutral wire (usually white insulation) from the fixture to the white wire from the power source.
---Attach the fixture grounding wire (usually green insulation or bare wire) to the mounting plate with the green
grounding screw, and then connect it to the house grounding wire with the wire nut.
Carefully put the wires back into the outlet box.
4. Attach the back plate to the mounting plate by inserting the fixture mounting screws, then secure it with the
two ball nuts.
5. Attach the thinner rubber pads onto the sockets and place thicker rubber pads between interior glasses and
exterior glasses and make sure the holes should be aligned.Then attach them onto the sockets and tighten
them with socket rings. (See Fig.1)
7. Install G9 bulbs (included). Check relamping label at socket area or packaging for maximum allowed wattage.
8. Secure the anti-knocking tubes onto the sockets.
G9 Bulb (I)
X4
Anti-Knocking Tube (J)
X4
Exterior Glass
X4
Interior Glass
X4
Thicker Rubber Pad (G)
X4
Thinner Rubber Pad (H)
X8
Mounting Screw (A)
Green Grounding
Screw (B)
Wire Nut (C)
Anchor (F)
Dry Wall Screw (E)
Ball Nut (D)
Mounting Hardware
(1 SET)