Assembly And Installation Instructions

Thinner Rubber Pad (H)

Thicker Rubber Pad (G)

ASSEMBLY AND INSTALLATION

INSTRUCTIONS

NOTES: 1. Before installing, consult local electrical codes for wiring and grounding requirements.

2. READ AND SAVE THESE INSTRUCTIONS.

Hardware Package (included):

WARNING:

TO AVOID RISK OF ELECTRICAL SHOCK, BE SURE TO SHUT OFF

POWER BEFORE INSTALLING OR SERVICING THIS FIXTURE.

Fig.1

G9 Bulb (I)

Max.40W (Included)

Anti-Knocking

Tube (J)

Ball Nut (D)

Interior Glass

Exterior Glass

Thinner Rubber Pad (H)

Socket

Socket Ring

Back Plate

Fixture Mounting Screw

Lock Nut

Mounting Plate

House Grounding Wire

Green Grounding Screw (B)

Fixture Grounding Wire

Wire Nut (C)

Outlet Box

Fixture Wire

Anchor (F)

Dry Wall Screw (E)

Mounting Screw (A)

Set Hole

Thicker Rubber Pad (G)

Thinner Rubber Pad (H) G9 Bulb (I) Anti-Knocking Tube (J)

Mounting Screw (A)

Green Grounding

Screw (B)

Wire Nut (C)

Anchor (F)

Dry Wall Screw (E)

Ball Nut (D)

PAGE 1
ASSEMBLY AND INSTALLATION INSTRUCTIONS WARNING: TO AVOID RISK OF ELECTRICAL SHOCK, BE SURE TO SHUT OFF POWER BEFORE INSTALLING OR SERVICING THIS FIXTURE. NOTES: 1. Before installing, consult local electrical codes for wiring and grounding requirements. 2. READ AND SAVE THESE INSTRUCTIONS.
PAGE 2
Installation Steps Turn off the power at fuse or circuit box 1. Unsecure the ball nuts, carefully remove mounting plate from back plate. 2. Attach the mounting plate to the wall. a) If the wall material is wood: Attach the mounting plate to the outlet box by using two mounting screws, then secure the dry wall screws through the set holes to the wall. b) If the wall material is cement: Place the mounting plate to the outlet box and mark the target on the wall from the set hole for drilling two holes.