Assembly And Installation Instructions

ManualsBrandsLatitude Run ManualsCeiling LightsAries 1 - Light Single Drum LED Pendant

ASSEMBLY AND INSTALLATION

INSTRUCTIONS

NOTES: 1. Before installing, consult local electrical codes for wiring and grounding requirements.

2. READ AND SAVE THESE INSTRUCTIONS.

Hardware Package (included):

WARNING:

TO AVOID RISK OF ELECTRICAL SHOCK, BE SURE TO SHUT OFF

POWER BEFORE INSTALLING OR SERVICING THIS FIXTURE.

Turn off the power at fuse or circuit box

Mounting Plate (A)

Green Grounding

Screw (E)

Fixture Mounting

Screw(D)

Mounting Screw (B)

Wire Connector (C)

Installation Steps

Lock Nut (F)

Upper Rod

Middle Rod

Lower Rod

Shade

Lock Ring

PC Diffuser

Ball Nut (G)

Threaded Pipe

Coupling

Flat Washer

Cover

Threaded Pipe

Fixture Canopy

Ball Nut (G)

Warning: LED electronics can be damaged by

electro static discharge (ESD)shock. Before

installation, discharge yourself by touching a

grounded bare metal surface to remove this

hazard. To avoid damage, do not touch the

LED module.

Outlet Box

House Grounding Wire

Wire Connector (C)

Fixture Mounting Screw (D)

Mounting Plate (A)

Green Grounding Screw(E)

Lock Nut(F)

Mounting Screw(B)

1. Attach two fixture mounting screws to the mounting

plate, and then secure it with two lock nuts. Adjust

the length of the fixture mounting screws if necessary.

2. Attach the mounting plate to the outlet box using two

mounting screws.

3. Attach the cover onto shade and let the threaded

pipe throught the hole of cover, then tighten it with

flat washer and coupling.

. Rod Connections:

a. Thread the fixture wires from the fixture through the

lower rod, and then secure the lower rod onto fixture

using the threaded pipe.

b. Thread the fixture wires through the middle rod, and

then secure the middle rod onto the lower rod using

the threaded pipe.

c. Thread the fixture wires through the upper rod, and

then secure the upper rod onto the middle rod using

the threaded pipe.

d. Thread the fixture wires through the fixture canopy,

and the secure the fixture canopy onto the upper rod

using the threaded pipe.

Note: Height adjustable from 10-3/4" to 64".

Use fewer rods if shorter length is desired.

Summary of content (3 pages)

PAGE 1
ASSEMBLY AND INSTALLATION INSTRUCTIONS WARNING: TO AVOID RISK OF ELECTRICAL SHOCK, BE SURE TO SHUT OFF POWER BEFORE INSTALLING OR SERVICING THIS FIXTURE. NOTES: 1. Before installing, consult local electrical codes for wiring and grounding requirements. 2. READ AND SAVE THESE INSTRUCTIONS.
PAGE 2
5. Pull out the source wires from the outlet box. Make wire connections using wire connectors as follows: ---Connect the black wire from the fixture to the black wire from the power source. ---Connect the white wire from the fixture to the white wire from the power source. ---Attach the fixture grounding wire to the mounting plate with the green grounding screw, and then connect it to the house grounding wire with a wire connector. Carefully put the wires back into the outlet box. 6.
PAGE 3
The following parts are available for re-order if damaged or missing. Spare Parts List: Mounting Strap (A) Fixture Mounting Screw(D) Mounting Screw (B) Green Grounding Screw (E) Wire Connector(C) Lock Nut (F) Mounting Hardware (1 SET) PC Diffuser X1 Finial (G) Acrylic Cover X1 Lock Ring X1 Driver X1 5-YEAR LIMITED WARRANTY: All products are warranted to be free of defects in material and workmanship for five (5) years from date of purchase.