Installation & Assembly

ASSEMBLING & INSTALLATION INSTRUCTIONS
WARNING! SHUT POWER OFF AT FUSE OR CIRCUIT BREAKER .
ASSEMBLING THE FIXTURE (Fig.1)
1. Shut off the power at the circuit breaker box. Remove old fixture
and all hardware from Junction Box.
2. Carefully unpack your new fixture and lay out all the parts on a
clear area. Take care not to lose any small parts necessary for
installation.
3. Attach the tube (G) to the coupling of the fixture body(H) , attach
the tube(F) ,(E) and (D) onto the pipe nipple of the tube (G), by
turning it clockwise until tight. Attach the open link(C) hook the
small loop of canopy(A) and tube(D), then close the open link(C).
4. By measuring, determine correct distance hole in mounting plate,
then drilled two holes(by measuring distance hole) in the ceiling at
junction box of side; raise the plastic anchor insert the hole. Thread
the two mounting screws about 1/4" into the pre-drilled holes in the
mounting plate, spaced about the same distance apart as the holes in
the fixture canopy(A). Attach the mounting plate to the junction
box with two junction box screws and two wood screws, tighten
screws securely with screwdriver. The side of the mounting plate
marked "GND" must face out. The junction box is not included.
5. While holding the canopy(A) towards the ceiling, connect the
electrical wires as Shown in Fig.2, making sure that all wire nuts
are secured. You may have to wrap the connections with electrical
tape. If your outlet has a ground wire (green or bare copper),
connect the fixture ground wire to it. Otherwise connect fixture’s
ground wire directly to the Single bar with the green screw
provided. After wires are connected, tuck them carefully inside the
Junction Box.
6. Raise the canopy(A) on to the Junction box, aligning screws on
mounting plate with mounting hole in canopy and lock it securely
with the ball nuts(B).
7. Install the light bulbs in accordance with the fixture’s
specifications. NOTE: DO NOT EXCEED THE SPECIFIED
WATTAGE.
8. Attach the glass shade (I) to the lamp holder by turning it clockwise
until tight. Attach the glass shade (K) to the lamp holder, aligning
the hole with protuberance nut then lock it securely with knob
screw(J).
Your installation is now complete Return power to the junction
box and test the fixture.
Fig.1
Green Screw
(GND)
I
K
J
H
Fig.2
White or
HOUSE
Black
WIRES
(Hot)
Smooth
FIXTURE
WIRES
Black or
Ribbed
WIRES
FIXTURE
Bare Copper(Ground)
FIXTURE
WIRES
Copper
(Ground)
HOUSE
(Neutral)
WIRES
White
Bare
Green or
WIRES
HOUSE