Assembly Instructions Caution : You must read this before you proceed TANK HOLDER Shall be used this TANK HOLDER Instruction with the Fire Table Instruction together.
A Front Panel 1 B Back Panel 1 C Side Panel 2 D Top Panel 1 E Stand (pre-assembled wing screw) 1 Description QTY ① Screw (M5 *10MM) 17 ② Screw (M6 *30MM) 3 ③ Leveller 4 ④ Screwdriver 1 Hardware Label Picture Page 2 OF 10
Assembly Preparation Before *Before beginning assembly of product, make sure all parts are Beginning present. Compare parts withpackage contents list. If any parts is Assembly: missing or damaged,do not attempt to assemble the product. Assembly Steps OVERVIEW Top Panel (D) Front Panel (A) Side Panel (C) Feet (③) This Tank Holder has multiple parts and may require up to 30 minutes to assemble.
Step 1 ③ ③ Assemble the 4 Leveller (③) to the bottom of the Front Panel (A) and Back Panel (B). Step 2 E ① Attach the Front Panel (A) and the Back Panel(B) to the Stand (E) using M5 Screw (①), with Screwdriver(④). Do not over tighten Screw(①) while assembling the panels in order to adjust the panels as needed while assembling and make sure you follow the steps fully.
Step 3 ① Attach the Side Panel (C) to the Front Panel (A) and Back Panel (B) using Screw(①), with Screwdriver(④). Repeat the same process to install the other Side Panel. Step 4 D ② Attach the Top Panel (D) to the Back Panel (B) using M6 Screws (②) with Screwdriver(④).
Step 5 If the Tank Holder wobbles, adjust the Pre-installed Levellers at the bottom of the Panel (A) & Panel(B) until the Tank Holder is level. This Tank Holder can only be used on a flat, level surface. Make sure all parts are connected and securely locked into position. Your Tank Holder is ready for use. Instructions for use Step 1 E Place a 20 lb. Propane Gas Tank (not included) on top of Stand (E). Turn the Preassembled Wing Screw on the Stand (E) clockwise to secure the Gas Propane Tank.
Step 2 Feed the Regulator Hose (from your Gas Appliance) through the bottom of the item. Step 3 Step 3.1 Step 3.
Step 3.1 Connect the Regulator (from your Gas Appliance) to the Gas Propane Tank. Step 3.2 Then close the Top Panel (D). CAUTION! Open the cover to connect or disconnect your Regulator and to open or close the Gas Propane Tank Valve. Make sure that the Hose is not pressed underneath the item. MAXIMUM WEIGHT CAPACITY: This item can withstand an additional weight of 30 lbs. • This item is intended for outdoor use only. • Do not use near flammable or combustible objects.
Questions & Answers about Proposition 65 • What is Proposition 65? Proposition 65 requires businesses to provide warnings to Californians about significant exposures to chemicals that cause cancer, birth defects or other reproductive harm. These chemicals can be in the products that Californians purchase, in their homes or workplaces, or that are released into the environment.
