Caution : You must read this before you proceed Chair Label Picture Description QTY A Chair - Backrest 1 B Right Armrest 1 C Left Armrest 1 D Seat 1 E1 Back Cushion 1 Page 1 OF 6
F1 Seat Cushion 1 Description QTY ① Plastic Cap 13 ② Bolt M6*45mm 9 ③ Washer 13 ④ Spring Washer Ø16*2mm 13 ⑤ Allen Key 1 ⑥ Bolt M6*40mm 5 Label Picture Before Beginning Assembly: Page 2 OF 6
Overview Chair - Backrest(A) Back Cushion(E1) Right Armrest(B) Seat Cushion(F1) Left Armrest(C) Seat(D) This Chair has multiple parts and may require up to some 30 minutes to assemble. To give you an overview of the Chair parts, the above picture is to help you put the various parts into perspective. Please read through the instructions herebelow to familiarise yourself with the parts and steps before assembly. Step 1 Open the carton and place all the parts onto a clean and soft surface.
Step 2 Place the Seat (D) between the Right Armrest(B) and Backrest(A). Attach the Seat(D) to the Right Armrest(B) with hardware as picture 3 and 4 shows. Use an Allen Key(⑤) to partially tighten these. Do not fully tighten the bolts. Step 3 Place the Left Armrest (C ) against the Backrest(A) and Seat(D). Make the metal rod on the Backrest(A) insert into the MOUNTING POSITIONs of the Left Armrest(C ) as picture 5 shows. Attach the Left Armrest(C ) to Backrest(A) with hardware as picture 6 shows.
Step 4 Tighten all bolts completely. Put the Plastic Cap(①) to cover the bolt heads, adjust the Leveler to ensure good stability. Step 5 Put the Seat Cushion(F1) & Back Cushion(E1) on the Chair It is ready for use. This Chair can only be used on a flat, level surface.
What is Proposition 65? Proposition 65 is a California law that requires warning labels on products that may contain one of more than 800-plus chemicals or ingredients that the California Office of Environmental Health Hazard Assessment (OEHHA) has deemed to cause cancer or other reproductive toxicity.
