Assembly Instructions

Step 3
Step 4
Install the Legs(D) into the bottom of the Chair Seat(A) by placing a Washer
Ring(①) onto the threaded stem of the Legs.
And then insert the threaded stem into the threaded mounting position at each
Corner of the Bottom of the Chair Seat(A).
Tighten by turning the Legs clockwise.
Note: The use of Washer Rings(①) are OPTIONAL and are especially useful
to help alleviate slight wobbles.
Some Legs may need more than one Washer Ring whilst some Legs may not
need any.
Position arm sofa right side up and test for stability on a Level Surface.
Add or remove Washer Rings(①) where needed to achieve stability.
Stand the Chair Seat(A) up as show in the left Picture.
Attach the Connecting Piece(⑦) to Chair Seat(A) using Bolts(④), Spring
Washers(⑤), and Flat Washer (⑥) with Allen Key(②) as shown in the right
picture.
Attach the Left Arm (E) to Chair Seat(A) on the other side by using Bolts(③),
Spring Washers(⑤), and Flat Washer (⑥) with Allen Key(②) as shown in the
picture.
Washer Ring(
①
)
D
D
E
E
A
A
D
4 of 8