PayClock QUICK START GUIDE READ THIS FIRST www.lathem.
Verify Contents Verify the contents of your system and make sure your computer meets the minimum system requirements before attempting installation.
PC600 Setup Options This Quick Start Guide is intended for Single Users installing on a Local Area Network (LAN). If you need to install the system using one of the other Setup Options please see the User’s Guide.
1 a Getting Started The following steps will show you how to connect the terminal, mount the terminal, install the system software, register the software, add employees and enable Multi-User if you choose. Connect the Power and Ethernet Cables (before Installing Software) c. c a. Plug the RJ45 network cable (1) into the Ethernet port and the Power Adapter plug (2) into the Power Adapter port which is located in the compartment on back of the terminal.
2 Install PayClock Software Go to the computer where you want to install the PayClock Software. Make sure your screen saver is not showing before inserting the installation CD. See User’s Guide for detailed instructions. PayClock Software For use with Lathem PC600 Terminal VERSION 6.0.3.0 P/N: PCW-CDPC6 Copy200 Selig Dr. right 0 .499 rved. 0.241 © 201 S.W. Atlanta, GA 30336 1.80 rights rese 0 L Al l athem Time Corporation. a. Insert the PayClock CD into the CD-ROM drive. b.
3 Add Employees Add employees and assign badges using the steps below. a. If an Update is available click “Yes”. When the update is complete you will be asked to re-enter your password then you should see the Get Started screen above. Click “Setup Now”. b. The Setup screen above shows you how to navigate PayClock and indicates the categories in the lower left corner. c. Click “Employees” located at the lower left corner of the screen. d. Click “ New” located at the top left corner of the screen.
How to Enable Multi-User This step is only necessary if you wish to enable Multi-User. PayClock is by default a Single User system. You must purchase and enable the Multi-User feature in order to access PayClock from other computers on your network. Please see the User’s Guide for detailed instruction. (1) (2) a. Click on the PayClock orb (1) in the upper left hand corner and select “Upgrade PayClock“ (2). c. At Number of Users select “Multi-User“ then click “Next“. b.
