Specification

______________________________________________________________________________
Dalton Enterprises, Inc., 131 Willow Street, Cheshire, CT 06410
Phone [phone] • Fax [phone] • www.latexite.com
Revised 04/28/15
TECHNICAL DATA SHEET
Latexite
TM
Line Striping Paint
Manufacturer Product#: White: 05030, Yellow: 05040, Blue: 05060
UPC#: White: 090932050303, Yellow: 090932050402, Blue: 090932050600
PHYSICAL PROPERTIES & PERFORMANCE
Appearance:
Thick Colored Liquid.
Maximum VOC:
Less than 50 g/L
Application Temperature:
50º F and rising.
Specific Gravity:
1.7
Viscosity:
5,000-10,000 cps
Weight Per Gallon:
13.6-14.2 lbs. per gallon
Color:
White, Yellow, Blue
Consistency:
Thick liquid.
Boiling Point:
>212º F
Cure Time (50% relative humidity, 70º F):
24-48 hours.
Freeze ability:
Do not allow to freeze.
Container Size & Weight:
4.75gallons, Approximately 65 lbs.
Premium lead free, VOC compliant, fast drying, 100% acrylic waterborne traffic paint. Conforms to Federal Specification TT-P-
1952E Type I & II as well as many state & federal specifications. For use on bituminous, Portland-cement, concrete pavements
and various sealcoat applications. Not recommended for use on concrete sealers containing silicone.
Coverage rates vary depending upon the condition of the existing blacktop. Average coverage per gallon for a 15mil, 4” wide line
is 320 ft. Rough / road-grade asphalts with larger aggregate can cause lower than normal coverage rates. Two thin coats are
recommended if product must be applied to uncured asphalt. The second coat may be applied 24 hours after first application.
Coats that are too thick or applied too soon may result in lifting or cracking of the asphalt.
Asphalt and concrete surfaces should be cured, clean, dry, and sound. Loose and lifting paint should be removed prior to
application. Concrete with sealers containing silicone, having a smooth finish, or efflorescence should be treated by etching or
abrasive blasting, as these conditions may interfere with adhesion. When the product must be applied on new asphalt, apply two
thin coats 7-8 mils each, allowing 24 hours between coats is recommended to help minimize cracking and lifting. While new
asphalt surfaces vary in length of time required for cure, one to two weeks is usually adequate for the application of waterborne
paints. Waterborne paints applied too thick or too soon may cause asphalt to lift and or crack. Regardless of surface condition, a
test stripe should be placed inconspicuously to determine if surface is suitable before continuing.
Formulated for use with either airless or conventional air atomized spray equipment. See equipment manufacturer’s
recommendations. Recommended paint thickness is 15 mils wet. For best results apply when air and surface temperatures are
above 50°F and relative humidity is below 85%. To improve spraying, paint may be heated to an optimum temperature of 110°F,
never exceed 160° F. Heating waterborne paint will not accelerate dry time. Thinning is not recommended. If thinning is desired,
use clean water, do not exceed 1 pint of water per 5 gallons of paint.
FEATURES
COVERAGE
SURFACE PREPARATION
APPLICATION