Specification

Dalton Enterprises, Inc., 131 Willow Street, Cheshire, CT 06410
Phone [phone] • Fax [phone] • www.latexite.com
Revised 09/28/16
Formulated for use with either airless or conventional air atomized spray equipment. See equipment manufacturer’s
recommendations. Recommended paint thickness is 15 mils wet. For best results apply when air and surface temperatures are
above 50°F and relative humidity is below 85%. To improve spraying, paint may be heated to an optimum temperature of
110°F, never exceed 160° F. Heating waterborne paint will not accelerate dry time. Thinning is not recommended. If thinning
is desired, use clean water, do not exceed 1 pint of water per 5 gallons of paint.
Avoid applying paint when rainfall is likely within 24 hours of application time. Avoid applying Paint when temperatures drop
below 50º F. When transporting this product, ensure that the container is secured and the lid is secure. Do not allow the container
to tumble as this may loosen the lid and allow leakage to occur. Do not transport on passenger seats or inside the passenger
compartment of any vehicle. Protective clothing and eyewear should be used during application.
While wet, clean up with soap and water. Dried paint is very difficult to remove. Containers are recyclable. Do not heat or store
container in temperatures above 110º F. Store in a cool dry area. KEEP FROM FREEZING Product is Non-Hazardous.
Latex-ite
®
Line Striping Paint is for exterior use only. Keep out of reach of children. Keep container capped when not in use.
Non- flammable.
Emergency & First Aid Procedures:
Eyes: Immediately flush with clean water for 15 minutes while holding eyelids open; consult a physician.
Inhalation: If overcome by mist or vapor, remove from exposure immediately; call a physician. If breathing is stopped
or irregular, start resuscitation, administer oxygen.
Skin: Remove any contaminated clothing and wash skin with soap and warm water.
Ingestion: DO NOT INDUCE VOMITING even though vomiting may occur. If vomiting occurs, keep head below hips
to prevent aspiration of liquid into the lungs. Get immediate medical attention.
The methods and techniques described herein represent some that have been used successfully to obtain desired results. Allow
new pavement to fully cure- one to two weeks is usually adequate for the application of waterborne paints. If water “beads up”
on pavement it has not fully cured. All variations in asphalt, climate conditions and equipment cannot be anticipated by Dalton
Enterprises, Inc. The decision to use any of these methods and techniques is entirely at the election and responsibility of the user.
Sealer is warranted from defects for a period stated on the pail from date of purchase when applied according to our application
instructions. Since seller cannot control the manner of use of its products after their sale, seller will not be responsible for any
consequential or indirect damages. Manufacturer disclaims liability for areas that are flat, have ponding waters, poor drainage or
snow removal damage. If product is deemed defective, it shall be replaced by Dalton. No warranties will apply if the goods are
in any way altered or modified after delivery by seller. There are no express warranties which extend beyond the description on
the face hereof, manufacturer disclaims any implied warranties. This warranty does not include labor costs incurred for the
application, re-application or consequential damage costs. Failures due to acts of God, fire, structural defects or causes beyond
our control are excluded from this warranty. If repair products were used, Latex•ite
®
repair products must be used for warranty to
be honored. Two coats must be applied to validate warranty. Not applicable on commercial parking lots. This warranty gives
you specific rights and you may also have other rights which may vary from state to state. Original proof of purchase required for
warranty claims.
APPLICATION
PRECAUTIONS
CLEAN UP & STORAGE
!!!CAUTION!!!
WARRANTY AND DISCLAIMER