Installation Guide

1. 4.
2. 5.
3. 6.
Scan QR code. Follow the instructions in the Latch Manager
App to assign a device to a unit or common space.
Put hub into pairing mode. Tap ‘Pair’ button after the device
has been created to put the hub in pairing mode.
If mounting the Latch Water Sensor on the wall, connect the
external extension probe. Remove the waterproof plug that
covers the USB interface and connect the extension water
probe into the device terminal.
Put leak sensor into pairing mode. When the battery is
rst inserted, the leak sensor will ener pairing mode for 30
seconds.
In order for the sensor to work, both probes must have
contact with water. Attach probes to a clean, dry surface using
adhesive pad.
Adjust the height of the main unit and secure with an adhesive
pad on a clean, dry surface.
Battery
LED Indicator
Pairing /
Reset Button
Note: If a network is not found after 100 seconds, the sensor
will go into sleep mode. To wake the sensor again, press the
pairing button once to trigger the pairing process
ProbeProbe
If deploying the Latch Water Sensor on the ground, probes
should face the oor.