Installation Guide

Safety instructions
This product shall be installed and serviced by certied
professionals only.
The product is intended to be used as either a standalone access
control system or as a reader with a panel. Multiple Latch R devices
cannot be used to control a single access point.
Locations and wiring methods shall be in accordance with the
National Electrical Code, ANSI/NFPA 70.
There are no replacement parts available for this product.
Outdoor electrical boxes used for mounting are recommended to
be NEMA 3 or better.
Correct wiring insulation should be used during installation to
prevent the risk of electrical shock.
For UL compliant installations, UL requirements listed in this manual
supersede conicting information.
•
•
•
•
•
•
•
Testing and Maintenance Operation
•
•
Loose wiring & loose screws.
Normal operation (attempt to unlock with all possible methods).
Prior to installation, ensure that all wiring is secure. Each unit should
be checked annually for:
Impaired Operation
Units are designed to operate under adverse environmental conditions.
Under normal circumstances, they will function properly regardless
of outside conditions. However, units do not have secondary power
sources and cannot function without direct continuous power. If a
unit is damaged by natural causes or deliberate vandalism, it may not
function properly depending on the level of damage.
Electronic Specications
Latch R oers support for the following credentials:
•
•
Near Field Communication (NFC): ISO 14443A.
NFC Card Type: Mifare Classic.
Bluetooth: BLE 4.2 (iOS and Android compatible).
Maximum BLE distance of 10m.
7 digit passcode.
•
•
•
Congured as a reader, the Latch R can work with Brivo ACS6000,
Keyscan EC1500, Keyscan EC2500 and many other access control
panel systems.
Device requirement for setup
•
•
64 bit iOS device
Latest version of the Latch Manager App
Software Information
•
•
The Latch app is necessary for BLE unlocks and the manager app
is necessary to congure the Latch R.
The device using the Latch app to unlock the product can only be
used in the same manner as a physical credential, transmitting user
data to the reader interface within close proximity.
The device using the Latch app should employ a means of
verication such as a pin or biometric feature to unlock the device
before using the Latch app.
Access logs on the Manager app are able to distinguish the type
of unlock that was done on the device (NFC, Bluetooth, Proximity,
Passcode).
Certication was acquired with Latch app v.2.5.0.
•
•
•