User Manual

Laserworld Showeditor 2015

Version 2015/1.0 2015 Page 93

6.20.2. Enable SMS

Laserworld Showeditor supports the handling of Text Messages (SMS) for laser

projection interactivity. The mobile SIEMENS TC35I GSM module is supported. Other

mobile receivers haven’t been tested yet, but may work.

A control window for the SMS display shows. Choose the COM port the mobile

receiver is connected to. A baud-rate of 19200 should be sufficient. If distortions

happen, a slower baud-rate is recommended.

A click on “OK” establishes the connection to the mobile receiver and (if not done

yet) to the mobile provider (requires PIN code of the mobile card). It is

recommended to switching on the mobile in advance and entering the PIN-code.

If this has already been done, the request of the software asking for the PIN can be

skipped by entering “xxxx”.

It should work to enter the PIN in the software as well, but in case of a transmission

error the mobile receiver might become locked unintendedly.

The upper left area of the dialog (GSM Status) shows the actual status information.

The lower left area shows the received messages. The currently displayed message

with the laser is marked in the message table. Clicking on the very message allows

for editing it.

The way of displaying the messages can be set in the upper right area of the dialog

(Laser output): morphed or scrolling text are options for output, “None” suppresses

any output.

. 84: Fi

ure Editor: Menu Si

ns/Text Enable SMS