User Manual

Laserworld Showeditor 2015
Version 2015/1.0 2015 Page 73
mount the laser in a bigger distance to the projection surface. This makes it easier for
the scanners to handle the high point density, as the inertia doesn’t affect the
scanning in small angles too much.
As raster frames are so difficult to handle for scanners, they are very likely to flickering
if the scan speed is too low. This is a normal behaviour. To reduce flickering, either use
a bigger grid size to reduce the number of points, or use a faster scanning system.
Reducing the size of the projection can also help with significantly reducing the
flicker effect.
Menu Edit 6.15.
6.15.1. Color change
This tool allows for changing the color of several points (of the
same color), or to change the color of points (of the same
color) in a series of frames. This is how it works:
1. Select the desired new color of the points (see 6.3.4 for
details on color selection).
2. Mark one of the points of the figure that should be
recolored (perhaps it is necessary to activate “Show
Points” first to make single points visible).
3. A click on Edit->Color change opens a dialog to set
the options (see Fig. 63). Make the selections of your
choice there. If “Color of actually selected point” or
“Destination color” are not correct, click “Cancel”
and change your selection.
Fig. 63: Menu Edit/Color change. Dialog to change colors of points.
Fig. 62: Menu Edit