User Manual

Laserworld Showeditor 2015
Version 2015/1.0 2015 Page 63
figure hasn’t been saved yet, the “Save as” dialog opens and the figure can be
named and then saved.
6.5.2. Save As
This opens the standard “Save as” dialog, asking where the file should be saved to
and offering the possibility to enter a file name. Figures created with Laserworld
Showeditor are saved in the *.heb file format. Export to *.ild file format is possible as
well. Please refer to section 6.13.8 for further details on this.
Important: Special Characters in file names and file paths:
Due to the software being used internationally, it is not possible to use special
characters like ä, ö, ß, é etc.. If any of these characters are used for naming a file or
a file path, an error message is displayed.
It is also important to not use any blank spaces in file or folder names, this is likely not
to work.
6.5.3. Save All
“Save All” saves all figures of the Figure Table, so changes that have been made to
several figures are saved all at once.
Textbox „Grid“ 6.6.
The textbox “Grid” (see Fig. 47) is used for changing the grid size of the drawing
area.
The smaller the number, the more detailed is the grid. Values between 1 and 300 are
possible. Value 1 means “no grid at all”. This setting is sometimes necessary for
modifying points that cannot be reached otherwise.
Output Path 6.7.
The output of the figure that is worked on can be
routed to different hardware output with the
output path selection tool.
The hardware interfaces (DACs) must have been
specified and assigned to output paths in Options -
> Hardware before they can be addressed (See
2.8.2). Of course this feature is not meant for being
used at live shows, it’s a feature used for testing the
output of a certain figure on different laser
projectors.
The paths directly refer to the output routing
settings made in Options -> Hardware.
Fig. 48: Setting of Output
Path