User Manual

Laserworld Showeditor 2015
Version 2015/1.0 2015 Page 22
Usually any supported hardware interface that is connected to the computer is
automatically detected by the Showeditor software. To make sure everything is
connected and assigned correctly, please verify the settings.
Important information on Settings and their effect:
Changes to any parameter have immediate effect. To preserve the settings even
after a restart of Showeditor, a click on “Save Settings and Close Window” writes
them to the startup configuration file.
2.8.1. Setting “Others”:
Settings can be accessed in the Options menu, then change to the tab Others. If
you require to changing the interface language of Laserworld Showeditor, this can
be done here (e.g. English, see Fig.10).
If a correctly licensed ShowNET interface is detected, the corresponding serial
number of this interface is shown here.
In the lower part of this settings tab the standard paths of Showeditor are defined.
The standard settings are fine in most cases.
2.8.2. Setting “Hardware”:
Change to the tab Hardware. Hardware devices are detected automatically, but
can be custom assigned per channel in this tab.
Up to 16 Digital-Analogue-Converters are supported by the software, so the very
hardware device can be routed to the respective output channels.
Fig. 8: Menu: Options. Language selection, licensing information