User Manual

Laserworld Showeditor 2015
Version 2015/1.0 2015 Page 140
on/off), but then the NOTE OFF macro is called, which sets all DMX-channels to 0. This
may be an unwanted effect if intelligent lighting is used.
To only set one Channel to 0, e.g. the channel for brightness, it is necessary to write a
special macro doing exactly that.
“Intelligent”-DMX 11.6.
A click on the button “Use intelligent DMX devices” changes the interface of the
DMX-window (Fig.134)
Before being able to use any intelligent devices, a profile for each intelligent fixture
needs to be created.
11.6.1. Button: Edit DMX-Device
Select or edit an intelligent DMX device with this button. A new dialog
opens that allows for specifying the configuration for the devices, see Fig. 131.
The example in Fig. 132 shows a very basic and simple profile of an RGB moving
head. The start address is set to DMX Channel 1
Fig. 130: DMX / Intelligent DMX Window