User Manual

Laserworld Showeditor 2015
Version 2015/1.0 2015 Page 138
Edit Steps 11.3.
11.3.1. Buttons: Cut/ Copy/ Paste
With these buttons macro steps can be cut, copied and
pasted.
11.3.2. Button: Create new DMX-Macro
Use this button to create a new macro.
File 11.4.
11.4.1. Buttons: Save/ Save as/ Save all
With these buttons macros can be saved, saved with a
different name or all present macros can be saved with one
click.
11.4.2. Button: Close Window
A click on this button closes the DMX window.
Additional Elements (Output, Master, Mapper etc.) 11.5.
11.5.1. DMX Interface
The DMX interface(s) are configured in the Figure
Editor Options -> DMX. Please see Chapter 8.5 and
following.
11.5.2. Scrollbar DMX Master
The master scrollbar applies to all DMX channels. It is
comparable to the master-volume of an audio-
mixer.
If the “Master Sensitivity” has been set to “false”, the
DMX master fader has no influence on “Intelligent”
DMX-devices. See the chapter 11.6 about
“Intelligent DMX” for further details.
11.5.3. Button: Start DMX Output
A click on the button “Start DMX Output” enables the DMX output on the hardware
device (switches off black-out mode).
On starting the DMX-Output the step timers are activated. The start/stop of the DMX-
Output happens automatically on the start/stop of a laser show.
Fig. 125: DMX-Editor: Edit
Step
Fig. 126: DMX-Editor: File
Fig. 127: DMX-Editor:
Additional elements (Output,
Monitor, Mapper...)