User Manual

Laserworld Showeditor 2015
Version 2015/1.0 2015 Page 113
The color correction dialog provides another method for the basic color correction
setup. One main feature, however, is the possibility to make the color adjustments
when running the laser sources in cw mode (full power).
This dialog was used in former times for the colour correction and today it is not really
necessary any more. Nevertheless it can be used to make a pre-setup of the colour
correction anymore.
When having made a selection, the info area at the bottom provides further details.
Follow the instructions given in the info area.
Select either “Laser CW mode” to compare the
laser color balance and brightness of the lasers in
full power mode or select “Laser blank mode” to
compare color balance and brightness in normal
modulation mode. For configuring the white
balancing for a laser show, use the “Laser blank
mode” in combination with Helix scanning.
In case the laser projector is not equipped with R-
G-B laser sources but only with one or two colors,
the corresponding checkbox of the very color shall
remain unchecked, so the control signal that
comes in for the missing color is distributed to the
existing color(s).
On clicking “Proceed”, the selections made are
passed to the general color correction tab and the
Color correction dialog closes.
8.10.4. Extended Color Correction (Min/Max scroll-bars for RGB)
Fig. 98 shows the extended color correction:
Each color channel can be individually adjusted: The extended color correction
allows for configuring a non-linear dimming behaviour per color channel. This feature
Fig. 97: Dialog Optimize Output
/ button Color Correction
Fig. 98: Options Window, Extended Color Correction