User Manual

Laserworld Showeditor 2015
Version 2015/1.0 2015 Page 112
8.9.10. Output correction – alternative method
The alternative method for the geometric correction allows for distorting the
projection are with click-dragging the mouse. This method is very quick and
especially suitable if settings don’t need to be 100% accurate.
Tab “Color Correction” 8.10.
The Color Correction is used for specifying the power levels per laser source color
channel. This Tab also provides the options to set safety zones (beam attenuation
map) and control the color handling behaviour.
8.10.1. Show Blanked Lines
This option is a help for setting up the correct values. If checked, even the invisible
movement paths of the beam are made visible. To distinguish them from “normal”
lines (un-blanked), they are colored RGB in small bits. (single color lasers show
colored-black lines).
Attention! If a figure consists of zero points (actually no figure), a single beam is
projected! A warning message is displayed in this case.
8.10.2. Intensity = Brightest Color / Intensity = Grey-Scale
There are two options how the intensity of color output can be calculated, which
can be selected here. Changing the standard setting (Brightest Color) only makes
sense for applications where the intensity signal of the DAC is used. Grey-Scale leads
to overall less bright output color, however this option may be required under certain
circumstances.
8.10.3. Button Color-Correction
The click on this button opens the Color Correction dialog shown in Fig.98.
Fig. 96: Options Window, Tab “Color Correction”