User manual

Manual: Laserworld Proline Series

page 8 / 36

8. Operation

1. Connect the power cable to the device and then to the mains

2. Insert key and turn it „on“

3. Press the „on/o“ switch on. The „on/o“ switch shines green now. Attention! The pro-

jector may emit laser beams immediately.

4. Mode selection:

Please use the push buttons below the LCD display to select the dierent modes

Auto mode:

Push the Menu button until MODE: AUTO is displayed. Press the ‚UP‘ and/or ‚DOWN‘

buttons to browse the mode and press ‚ENTER‘ to select the desired program.

Music mode:

Push the Menu button until MODE: MUSIC is displayed. Press the ‚UP‘ and/or ‚DOWN‘

buttons to browse the mode and press ‚ENTER‘ to select the desired program.

Control the sensitivity of the microphone by pushing the Menu button until MODE:

SETTING is displayed. Press the ‚UP‘ until MODE: SETTING - MUSIC is displayed

and the ‚UP‘ and/or ‚DOWN‘ buttons to set the sensitivity of the microphone. Press

‚ENTER‘.

DMX mode:

Push the Menu button until MODE: DMX is displayed. Press the ‚UP‘ and/or ‚DOWN‘

buttons to set the DMX address and press ‚ENTER‘.

Connect a DMX controller to operate the laser.

The laser uses 16 DMX channels, so make sure that the next device uses an address that

doesn’t overlap with this range.

Browse the Menu

Enter

LCD Display