User Manual

Manual: Club Series MKII
EN page 11 / 12
ILDA control: Connect your device („ILDA IN“) via an ILDA cable to an interface
/ controller. Use a laser control software, to run the device. Use „ILDA OUT“
to connect it to another device. In ILDA mode all DIP switches should be
switched o.
Master-Slave-Mode: To use the daisy chain / Master-Slave-Mode connect two
(or more) laser projectors of the same series via DMX cables:
Master projector (DMX out) -> DMX cable -> slave projector 1 (DMX in) ;
slave projector 1 (DMX out) -> DMX cable -> slave projector 2 ...etc.
6. To turn o the device switch it o („OFF“), switch the key to „OFF“ and discon-
nect the power cable from the mains.
7. Close the beam block shutter to prevent laser output: Loose both screws
and slide the shutter in front of the window. Tighten the screws again. Do it
conversely to open the beam block shutter.
DMX setting at the slave
projector:
DMX cable
Slave projector
Master projector
Choose stand-alone or
sound-to-lightmode at
the master projector
(see above)