Manual
Laserworld EL-400RGB MK2 Laserworld EL-400RGB MK2
8 / 28 9 / 28
8.2. Automatic mode, Stand-alone operation
Set the device to auto mode:
8.3. Music mode, Sound-to-light operation
Set the device to music mode:
Control the music sensitivity with the rotary button at the back panel.
The LED is ashing when the device is triggered.
8.4. DMX-512 mode
Switch 10 must be set to „o“, the other switches are used for setting the DMX
address:
Connect a DMX controller to operate the laser.
Use the switches 1 - 9 to set the DMX address of the laser. Each switch
represents a number. To dene a number use the preceding number and
multiply it by 2:
Switch 1 2 3 4 5 6 7 8 9 10
Number 1 2 4 8 16 32 64 128 256 Mode Switch
The laser uses 9 DMX channels, so make sure that the next device uses an
address that doesn’t overlap with this range.
Channel Value Function
1 0 - 49 Laser o
50 - 99 Sound mode
100 - 149 Automatic mode
150 - 199 Static pattern (DMX mode)
200 - 255 Dynamic pattern (DMX mode)
2 0 - 255 Pattern selection
3 0 - 10 Center Position on X axis
11 - 255 X axis positioning
4 0 - 10 Center Position on Y axis
11 - 255 Y axis positioning
5 0 - 255 Scanning speed
6 0 - 255 Dynamic pattern speed
7 0 - 255 Zoom / size
8 0 - 255 Color
9 0 - 255 Color segment
Please note that a pattern can not necessarily be combined with each eect.
8.5. Master-Slave mode
This mode will allow to link up several units together without a controller.
Choose a unit to function as Master, set the dipswitch to select Sound mode
or Automatic mode. The other units must be set to slave mode (Switch 10
must be set to „o“). Use standard XLR cable to chain your units together via
the XLR connector on the rear of the units. After the slave units are turned
„on“ they will reset and start in Slave mode to mirror the behaviour of the
master unit.
8.6. Turn laser o
To turn o the device switch it o („OFF“), switch the key to „OFF“ and discon-
nect the power cable from the mains.