User manual
Manual: Diode Series
page 8 / 36
8. Zoom
Use the Zoom-X / Zoom-Y knobs to change the pattern size on the X resp. Y axis.
9. Modes / Functions
The modes can be selected by the ‚MODE‘ button below the LCD display. Use the ‚UP‘ or
‚DOWN‘ buttons to set the DMX address and press ‚DIR‘ to select the requested mode or
conrm the DMX address (see below).
• Automatic mode
Select this mode by pressing the MODE button until ‚Auto‘ is displayed and conrm by
pressing DIR. Now the laser device projects patterns in random order
• Music mode
Select this mode by pressing the MODE button until ‚Aud1‘ is displayed and conrm by
pressing DIR. Control the sensitivity of the microphone by the SOUND trim pot at the
rear side of the device. The LED is ashing when the device is triggered.
• DMX mode
Change the DMX address by using the UP and/or DOWN buttons and conrm the DMX
address by pressing the DIR button. By pressing the UP or DOWN buttons for 3 seconds,
the DMX values increases / decreases in intervals of +/- 10. We recommend to connect a
DMX controller to operate the laser.
The laser uses 12 DMX channels, which are explained in the following table.
Channel Value Function
1 Mode Select 0 - 63 Laser o
64 - 127 Music mode
128 - 159 Auto mode (beam patterns)
160 - 191 Auto mode (graphics)
192 - 255 DMX mode
2 Pattern selection 0 - 87 Graphics patterns
88 - 253 Beam patterns
254 - 255 Laser o
3 Strobe 0 no strobe
1 - 255 Strobe (fast to slow)
4 X-axis movement 0 no movement
1 - 167 manual positioning / oset
168 - 188 movement left to right (slow to fast)
189 - 209 movement right to left
210 - 254 movement left to right