User manual

Manual: Diode Series
page 11 / 36
1. There is a ap on the front panel. Unscrew the screws and carefully remove the ap.
Both dichros are right behind the ap.
2. Now you can set the color convergence using the two dichros, by carefully adjusting the
allen screws.
3. With the correct setting of the color balance ( put red, green and blue on top) you get a
perfect white.
4. After setting up, cautiously attach the ap back on the front panel of the laser unit.
Important Note:
Operate scanners/galvos only at appropriate speed according to the res-
pective scan angle. Too high scan speed will damage the scanning system.