User manual
Manual: Diode Series
page 10 / 36
Channel Value Function
100 - 119 purple
120 - 138 cyan
139 - 164 multi-color
165 - 248 changing multi-color (fast to slow)
249 - 254 changing multi-color 2
255 multi-color 2
Please note that not each pattern can be combined with each eect.
• ILDA control:
Connect your device („ILDA IN“) via an ILDA cable to an interface / controller. ILDA mode
starts immediately. Use a laser control software, e.g. Laserworld Showeditor, to run the
device. Use „ILDA OUT“ to connect it to another device.
• Master-Slave-Mode:
To use the daisy chain / Master-Slave-Mode connect two (or more) laser projectors of
the same series via DMX cables:
Master projector (DMX out) -> DMX cable -> slave projector 1 (DMX in) ;
slave projector 1 (DMX out) -> DMX cable -> slave projector 2 ...etc.
• Timer
This device has an integrated timer. Press the MODE button until the displays shows the
timer. Press DIR to conrm.
• Animations
Select this mode by pressing the MODE button until the display shows Auoo and con-
rm by pressing DIR. Now the laser device projects animations in random order
10. To turn o the device switch it o („OFF“), turn the key ‚OFF‘ and disconnect the power
cable from the mains.
Convergence settings for dichros - Service openings
Settings for convergence must be made while the laser unit is running, therefore please take
care about your safety rst - Don‘t look directly at the laser beam!
To use this mode, please press
the MODE button until the dis-
play shows SLAV and conrm
by pressing DIR.
DMX cable Slave projectorMaster projector
Select auto or
music mode at the
master projector
(see above)