Owner's manual
Warranty Information
Registration of your product is required in order to receive warranty service.
Log on to www.lasermax.com to fill out the registration form.
?
Questions or Comments?
Have Questions? Contact us
by phone, e-mail, or on the web
Phone: --, or
--.
Fax: --
E–Mail: customerservice@lasermax.com
For warranty registration visit
www.lasermax.com
LaserMax does not warranty the alignment or
function of the Guide Rod Laser for ported,
compensated, or altered from stock factory
conguration rearms. LaserMax, Inc. laser
products, except expendable parts, are warranted to
be free from defects in material and workmanship
for a period of three years from the date of purchase,
provided in the warranty registration process for
LaserMax. Expendable parts shall be dened as
batteries, springs, and replaceable plastic parts.
Expendable parts of some models have denite
life expectancies. ey should be replaced as
recommended to protect the laser and preserve
your warranty. is warranty shall benet, and
may be enforced only by the initial purchaser of
the laser system and is not transferable. Warranty is
limited solely to repairing or replacing the part(s),
at the discretion of LaserMax, Inc.; which proves
to be defective during the warranty period. Parts
and equipment replaced under warranty will not
be returned. Parts and equipment repaired under
warranty will be covered for the remaining portion
of the original warranty period. is warranty
does not apply to equipment or parts which upon
inspection by LaserMax, Inc. are determined
by LaserMax, Inc. to have become defective or
unworkable due to abuse, mishandling, misuse,
alteration, negligence, improper installation or
maintenance, damage resulting from use of springs
not supplied with laser, damage resulting from
repair or attempted repair by anyone other than
LaserMax, Inc. or a repair facility authorized by
LaserMax, Inc., or other causes beyond the control
of LaserMax, Inc. All returns must have factory
labeling present and legible. All returns require a
return authorization number available from our
Warranty Department at ---. e
hours of operation are from a.m. to p.m. ,
Monday through Friday.
, .
.
,
, .
()
.
,
.
Initial Installation
A rst-time installation typically takes about minutes or less. Subsequent
installations and battery replacements can be accomplished in less than a minute. We
at LaserMax always strive to bring you superior technology. Please let us know what
you think of your LaserMax Guide Rod Laser by taking a moment to ll out your
registration at www.LaserMax.com. Again, thank you from all of us at LaserMax.
Batteries
Replacements are available from your dealer or direct from us. remove the
shrink wrap from the LaserMax battery packs (for .”, three Energizer or
equivalent batteries may be used in place of LaserMax battery packs/for Subcompact
” four Energizer or equivalent batteries may be used).
For longer battery life, avoid getting nger oils on the battery contact surfaces.
Operating temperature range for batteries is from degrees to degrees .
LaserMax recommends keeping a fresh set of batteries for carry and using older
batteries for practice.
Troubleshooting
Review installation instructions and install a second time to eliminate human error.
Pull slide back and allow it to slam forward two or three times to ensure contact.
Check batteries. Is the + side up? Are they clean and free from oil?
If using loose batteries, is the + side up on all of them?
Check the battery cap. Is there a gold contact pin?
Is the takedown lever/laser switch installed correctly? Excessive lubricant can insulate
the gun parts and break the circuit.
If there is still a problem, call the LaserMax Gunsight Technical Support and Warranty
Department at ---. Technical assistance is available from am to pm
Monday thru Friday. You can also nd video assistance by visiting
www.lasermax.com/Learn/Videos.aspx.
If the sight has to be returned for repair, call our Warranty Department for a return
authorization number sending the sight. LaserMax will not be responsible
for items returned without authorization. Do not return any parts or accessories not
requested by the Warranty Department.
Cleaning and Maintenance
e window on the muzzle end of the laser may become smoked-over during ring.
To clean, MAKE SURE PISTOL IS UNLOADED AND THE LASER IS OFF. Clean window
with lens cleaner or alcohol on a cotton swab.
LaserMax recommends replacing recoil springs on .” aer , and
Subcompact ” models aer , rounds.
DANGER
Laser radiation is emitted from
the front aperture of the laser
when the switch is activated.
WARNING
Avoid direct eye exposure to beam.
REMINDER
Aiming a laser beam at moving
vehicles including boats, aircra, trains,
and construction equipment may be
illegal. Check current applicable laws and
follow them accordingly.
Red Laser
CLASS 3R VISIBLE LASER
Output Power: <5mW
Wavelength: —nm
,
3495 Winton Place
Rochester, NY
Safety Compliance Labeling
e requires the label supplied with your laser be axed to the outside of the gun with the
arrow pointing towards the laser aperture.
–x –
–
LMS–XDMS
LMS–3XD
–
/ ***
–
xdm 4.5”
9mm/.40 s&w
xd 3”
9mm/.40 s&w
/
springfield model*
–
–
– –
*Please check model number to make sure you have
purchased the correct laser for your model gun.
***Please call LaserMax Customer Service
for replacement pricing and details
LASER MODEL
See it installed at
www.LaserMax.com
or nd it on
US Patent #: 5, 509, 226
European Patent #: 0728292
Customer Service: 1-800-527-3703
1-800-LASER-03
customerservice@lasermax.com