Operation Manual

07
RangeXtender RX
+
–
RangeXtender RX 30 RangeXtender RX 51 RangeXtender RX 52
1
2
+
–
–
+
Inserting the battery
Use the laser receiver RX for levelling over longer distances or when the
laser lines are no longer visible. Switch on with button F; control lamp G
will light up.
Working with the laser receiver RX
Set the line laser to hand receiver mode. The laser lines will now pulsate with
high frequency, making the laser lines darker. The laser receiver can detect
these pulsating laser lines up to a maximum distance of 30 m (RX 30) / 50 m
(RX 51 / 52). Minimum distance from the laser device about 3 m.
Now move the receiver field (B) of the laser receiver through the laser lines
upwards and downwards (horizontal laser line) and/or sideways (vertical laser
line) until the centre LED lights up. Now mark the horizontal and/or vertical
reference dimension.
Line lasers: This button switches hand receiver
mode on and off.
RX 30 / RX 52: This button is used to establish the
tolerance range.
RX 51: This button is used to adjust the sensivity.
GB
Manual_RangeXtender RX30_51_52_Rev.1110.indd 07 09.12.2010 15:50:57 Uhr