User Manual

18
GB
Hold function11
MAX/MIN function
9
Continuity test
10
1. Connect the red test prod to the V Ć input socket (12) and
the black test prod to the COM input socket (8).
2. Turn the rotary switch to position „
“.
3. Connect the measuring contacts to the object to be tested.
If the test has been positive, an acoustic signal sounds.
(< 30 Ć)
Press the „MAX/MIN“ button to deactivate the function.
The measured „MAX“ value is shown on the display and is
automatically updated, when a new maximum value is
detected.
Press the button again to display the „MIN“ value. This value is
updated, when a new „MIN“ value is detected.
Press the „MAX/MIN“ button again, to display the current
value. The „MAX“ and „MIN“ values are still being updated.
Press the button and hold it down for 2 seconds to exit this
mode.
2. 3.1.
Black
Red
To brie× y hold the current measured value, press the „HOLD“
button. In order to take measurements, this function must be
deactivated by pressing the button again.
Black Red
For continuity tests, the components must be
zero-potential.
!
Manual_MultiClamp-Meter_Rev.0710_GB.indd 18 12.08.2010 16:10:29 Uhr