operation manual

MultiMeter

Voltage measurement DC

To measure voltage, set the rotary switch to the " " position with

the corresponding measuring range (200 mV - 300 V).

Then connect the measuring contacts to the object to be tested.

The measured value acquired and the polarity appear on the display.

300 300

10A

BAT.

1.5V

200200

2000

200

2000

200

20k

2000

200

200m

20m

2000

black red

Notes on measurement

If the value of the measured variable is not known in advance,

set the rotary switch to the highest measuring range or use the 10A

connection with the 10A measuring range to measure current.

Then reduce the measuring range step by step until a satisfactory

resolution is achieved.

Connection of test prods

The black test prod (–) must always be connected to the

"COM socket". When taking current measurements > 200 mA

the red test prod (+) must be connected to the "10 A socket".

For all other measuring functions, the red test prod must be

connected to the "VmAΩ

-socket".

Before measuring, make sure that the test prods are

connected correctly as the built-in fuse could otherwise

trip and damage the measuring circuit.

COM VmA 10A